Installation; Mechanical Installation; Installing Communication Cable; Auxiliary Power Connection - ABB SPA-ZC 402 Installation And Commissioning Manual

1MRS755380
5.
5.1.
5.2.
5.2.1.
5.3.
5.3.1.
SPA/ Ethernet Adapter
SPA to IEC 61850 Gateway
Installation and Commissioning Manual

Installation

This chapter describes the installation of the SPA-ZC 402 module and the
Communication Engineering Tool (CET) for SPA-ZC 40x. For additional
information, such as technical data, maintenance and service, refer to Section 8.
Technical data and Section 9. Maintenance and service.

Mechanical installation

Screw the SPA-ZC 402 module on the cubicle's bottom or wall near the protection
relay. Pay attention to the length of the fibre-optic SPA cable when you are installing
the SPA-ZC 402 module.

Installing communication cable

Connect the fibre-optic SPA bus cable between IED and SPA-ZC 402. Connect the
LAN cable to the LAN connector of SPA-ZC 402. The other end of the cable is
connected to the IEC 61850-8 station bus through the Ethernet switch.

Auxiliary power connection

Voltage range for the external power connection (U
110-220 VDC, 100-240 VAC or
*
24-60 VDC
*
Table 5.2.1.-1 Screw terminal of U
Screw terminal
1
2
In addition there is an earthing screw for the protective earth conductor beside the
screw terminals in the casing.

Communication Engineering Tool for SPA-ZC 40x

System requirements

Communication Engineering Tool (CET) for SPA-ZC 40x runs on Windows 2000,
Windows XP and Windows Server 2003 operating systems. A PC capable of
running one of these operating systems is sufficient also for CET for SPA-ZC 40x.
For more information, refer to Section 1.4. Product documentation. The detailed
system requirements can be seen below.
20 MB free hard disk space if Microsoft .NET Framework 1.1, which is required
*
for running CET for SPA-ZC 40x, has already been installed.
100 MB free hard disk space, if the Microsoft .NET Framework 1.1 is not
*
installed. It is installed automatically if it is not found.
) is
aux
connection
aux
AC
L
N
SPA-ZC 402 SPA-ZC 402
DC
+
-
21