Registering Addresses Obtained Via An Ldap Server - Canon ImageRUNNER 2545i Sending And Facsimile Manual

5
NOTE
• To cancel a selected destination, select the destination again to clear the check mark.
• If both the Send function (optional for the imageRUNNER 2545/2535/2530/2525/2520)
is activated and the optional Super G3 Fax Board-AG1 is attached to the machine, you
can sort and limit the view of the displayed addresses by using the Type drop-down
list.
• The destinations you can specify may vary depending on the settings under <Send
Restriction Settings>. (See Chapter 4, "Customizing Settings," in the Remote UI
Guide.) For example, if E-mail Send is set to 'Do not allow' or 'Only allow sending to
own address', e-mail addresses are not displayed as the search results.
• If a fax number or I-fax address is specified as the destination, read the displayed
message ➞ press [OK].

Registering Addresses Obtained via an LDAP Server

Follow this procedure to register the destinations that are obtained by searching the
directory listings on the network using LDAP (Lightweight Directory Access
Protocol) servers.
Select the desired destination
from the search results ➞ press
[OK].
You can select up to 32 destinations.
If you press [Select e-mail for I-Fax], the
selected e-mail address can be specified
as an I-fax destination.
To continue searching, press [Back].
LDAP Server
4
4-61