Stamping Originals Which Have Already Been Scanned - Canon ImageRUNNER 2545i Sending And Facsimile Manual

Stamping Originals Which Have Already Been Scanned

The feeder directly applies a stamp (about 3 mm in diameter) on the front side of
originals after scanning them, so that you can distinguish scanned originals from
those that have not been scanned.
IMPORTANT
• The Stamp mode is available only when the following options are attached to the
machine:
- Stamp Unit-B1
- Feeder* (DADF-AA1 for the imageRUNNER 2545/2535 or DADF-AB1 for the
imageRUNNER 2530/2525/2520)
* Standard-equipped for the imageRUNNER 2545i/2535i/2530i/2525i/2520i.
• The Stamp mode cannot be used with the following modes:
- Document Size (except for [Auto]) (See "Specifying the Document Size," on p. 3-6.)
- Different Size Originals (See "Scanning Different Size Originals Together (Different
Size Originals)," on p. 3-15.)
- Direct Sending (See "Direct Sending," on p. 2-28.)
- Manual Sending (See "Manual Sending," on p. 2-31.)
1
Press
specify the destination.
NOTE
• For instructions on how to place your originals, see Chapter 2, "Basic Operations," in
the Reference Guide.
• For instructions on how to specify the destination, see "Basic Sending Methods," on
p. 2-2, or Chapter 4, "Specifying Destinations Easily and Quickly."
(SEND) ➞ place your originals into the feeder ➞

Stamping Originals Which Have Already Been Scanned

3
3-23