Canon ImageRUNNER 2545i Sending And Facsimile Manual page 124

NOTE
• For instructions on how to enter characters, see Chapter 2, "Basic Operations," in the
Reference Guide.
• The pause time differs in length, depending on whether it is entered in the middle or at
the end of a fax number.
- The pause time entered in the middle of a fax number (lower-case p) is set to four
seconds long by default. This can be changed to any length between 1 and 15
seconds. (See "Adjusting the Pause Time," on p. 7-25.)
- The pause time entered at the end of a fax number (upper-case P) is set to 10
seconds long. (This length cannot be changed.)
• Two or more pauses can be entered consecutively.
• You can press
4
You can specify the following optional settings:
[Sending Speed]:
[Long Distance]:
[ECM TX]:
(Clear) to clear your entry.
Press [Option].
Adjusts the transmission speed. Available speeds are '33600
bps', '14400 bps', '9600 bps', and '4800 bps'. If your document
transmissions are slow in starting, this may mean that the
telephone lines in your area are slow. Select a slower speed.
The default setting is '33600 bps'.
Specifies long distance settings. Available settings are
'Domestic', 'Long Distance (1)', 'Long Distance (2)', and 'Long
Distance (3)'. Use 'Domestic' for dialing domestic (local)
telephone numbers. Use 'Long Distance (1)' if communication
errors frequently occur when you make overseas calls (when the
overseas telephone number is registered in the Address Book). If
errors persist, try using 'Long Distance (2)' or 'Long Distance (3)'.
The default setting is 'Domestic'.
Sends documents with ECM (Error Correction Mode). ECM
reduces the effect of system and line errors on documents that
may occur when sending or receiving with another fax machine
that supports ECM. For more information, see "Sending with
Error Correction Mode (ECM Transmission)," on p. 7-23.
The default setting is 'On'.
4-17
Address Book
4