Canon ImageRUNNER 2545i Sending And Facsimile Manual page 286

Remedy 2 Disable data transmissions using SSL encryption by setting <Allow SSL (SMTP
Send)> in the E-mail/I-Fax setting to 'Off'. (See Chapter 3, "Setting up the
Machine for Your Network Environment," in the System Settings Guide.)
Cause 3 The machine detected a problem with the SSL server certificate and the
communication failed.
Remedy Check the SSL server certificate. For information on the certificate verification,
see Chapter 4, "Customizing Settings," in the Remote UI Guide.
The number of search results has exceeded limits. If the desired destination is not displayed,
change the search conditions and try again.
Cause The number of addresses that meet the search criteria exceeds the specified
maximum number of addresses to search.
Remedy 1 Narrow down the search criteria, and then search again.
Remedy 2 Increase the maximum number of addresses to search. (See Chapter 3,
"Setting up the Machine for Your Network Environment," in the System Settings
Guide.)
There are too many subdirectories.
Cause You have exceeded the maximum number of subdirectory levels allowed.
Remedy The directory level that you are trying to access cannot be specified. Specify a
different destination.
The send function currently cannot be used. Confirm with administrator.
Cause All the sending functionalities are disabled.
Remedy Check the following settings:
• <Send Restriction Settings> on the Send Function Authentication Settings
page (See Chapter 4, "Customizing Settings," in the Remote UI Guide.)
• Use Scan to Memory Media in Memory Media Settings (See Chapter 4,
"Setting the Send Function," in the System Settings Guide.)
Transmission has been suspended. Contact system manager.
Cause 1 Although [Specify LDAP authentication user address as the sender name] is
selected, the machine cannot obtain an e-mail address attribute from an
authentication server.
Remedy 1 Deselect [Specify LDAP authentication user address as the sender name]. (See
Chapter 4, "Customizing Settings," in the Remote UI Guide.)
Self-diagnostic Display
9
9-11