Canon ImageRUNNER 2545i Sending And Facsimile Manual page 290

# 0403
Cause The job failed because a file with the same name already exists. Generally, if a
file with the same name exists, a number ranging from 1 to 999 is added to the
tail of the name to prevent naming conflicts. However, this error occurred
because a file with the same number added to its file name already exists.
Remedy Rename the file, and then write the data again.
# 0404
Cause The job failed because the write protect switch of the USB memory media
device was on.
Remedy Turn off the write protect switch of the USB memory media device.
# 0406
Cause 1 The job failed because the USB memory media device was pulled out during
transmission.
Remedy Check that the USB memory media device is properly inserted, and then try
sending again.
Cause 2 An error occurred while data, such as image data, was being transferred to the
USB memory media device. (The connected device may be formatted with a file
system that is not supported by the machine.)
Remedy Check the status of the USB memory media device, or make sure that the
device is formatted with a file system supported by the machine (FAT16 or
FAT32), and then try again.
# 0407
Cause 1 The length of the full path to the specified file (or folder) exceeded the
supported limit.
Remedy The full path must not be longer than 120 characters. Change or shorten the file
name.
Cause 2 The transmission to the USB memory media device was not properly performed
because the length of the full path including the root and file name exceeded the
limit.
Remedy 1 The full path must not be longer than 120 characters. Change or shorten the file
name.
Remedy 2 Change the folder to which the data is saved.
Self-diagnostic Display
9
9-15