Installation Instructions - Kenmore C970-495022 Use & Care Manual

Installation Instructions

Clearances and Dimensions
A. Provide adequate clearances between the range and adjacent combustible surface (1.3cm (1/2") to the cabinet side walls
and the rear wall).
B. Location—Check location where the range will be installed. Check for proper electrical supply and the stability of floor.
C. Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface must be solid
and level.
FRONT
VIEW
76.2 cm (30")
Minimum *
Minimum to 1.3 cm
wall on either (1/2")
side of range.
91.4 cm
(36")
* 76.2 cm (30") minimum clearance between the top of the cooking surface and the bottom of an unprotected wood or metal
cabinet; or 61 cm (24") minimum when bottom of wood or metal cabinet is protected by not less than 0.64 cm (¼") flame
retardant millboard covered with not less than 0.038 cm (0.015") stainless steel, 0.061 cm (0.024") aluminum or 0.051 cm
(0.020") copper. 1.3 cm (½") clearance is minimum for the rear and sides of the range. Follow all dimensions requirements
provided above to prevent property damage, potential fire hazard, and incorrect countertop and cabinet cuts.
To eliminate the risk of burns or fire by reaching over heated surface units, cabinet storage spacelocated above the
surface units should be avoided. If cabinet storage is to be provided, the risk can be reduced by installing a range
hood that projects horizontally a minimum of 12.7 cm ( 5") beyond the bottom of the cabinets.
Electrical Hook-Up
This appliance must be connected to a grounded 120/240 volt or 120/208 volt, 45 AMP. Range outlet.
If no outlet is available, have one installed by a qualified electrician.
Location
Set your new range 1.3 cm (1/2") away from the rear wall and line it up
with the kitchen counters. Make sure there is at least 1.3 cm (1/2") of
clearance between each side of the range and the kitchen counters. Allow
7.6 cm (3") min. clearance between your range and the refrigerator, if they
are side by side.
Levelling
For good baking results, your range should be level. Screw type levelling
legs are provided at each corner of the range at the base. Remove the stor-
age drawer to adjust the levelling legs. (Refer to Storage Drawer section).
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED TECHNICIAN.
IMPORTANT: SAVE FOR THE LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE
THESE INSTRUCTIONS FOR FUTURE REFERENCE.
C
Minimum to
45.7 cm Maximum depth for
cabinets on ei-
(18")
cabinets above
ther side of
range top.
range.
B
RANGE
SIDE
VIEW
24" 61 cm (24")
30" 76.2 cm (30") 78.7 cm (31") 76.2 cm (30")
33 cm
(13")
122 cm (48")
Maximum
114.3 cm (45")
Door Open
30" Models
5
DIMENSIONS
A B C
63.5 cm (25") 61 cm (24")
66 cm (26")
A
91.4 ± 0.3 cm
(36 ± 1/8")
24" Models