Download  Print this page

Anti-Tip Brackets Installation Instructions - Kenmore 79031069100 Installation Instructions Manual

30" slide-in gas range (models with sealed top burners)
Hide thumbs

Advertisement

Anti-Tip
Brackets
Installation
Instructions
|
Models
Equipped
with
Leveling
Device
To reduce the risk of tipping
of the range,
the range must
be
secured
to the floor
by properly
installed anti-tip
bracket
and screws packed
with the
range. These parts are located
in the oven. Failure to
install the anti-tip
bracket
will allow the range to tip over
if excessive weight
is placed
on an open door or if a child
climbs upon it. Serious injury might result from spilled hot
liquids or from the range itself.
Follow
the instructions
below
to install
the
anti-tip
brackets.
If range
is ever moved to a different
location,
the anti-
tip brackets
must also be moved
and installed with the
range.
Tools
Required:
Adjustable
Wrench
Ratchet
Drill & 1/8"(0,32
cm) bit
5/16"
(0,8 cm) Nutdriver
Level
The anti-tip
bracket
attaches
to the floor at the back of
the range to prevent range from tipping.
When fastening
bracket
to the floor, be sure that screws do not penetrate
electrical
wiring
or plumbing.
The screws provided
will
work in either wood
or concrete.
1. Draw a center line (CL) on the floor where the range
should be installed.
Also draw a line on the floor
at
the range back position
if there is no wall.
(CL : Center line)
Door
Cabinet
2. Unfold
paper
template
and place it fiat on the floor
with the right rear corner positioned
exactly
on the
intersection
of the center and back lines you just drew
before.
(Use the diagram
below to locate
brackets
if
template
is not available
(Figure 15)).
3. Mark on the floor the location
of the 4 mounting
holes shown on the template.
For easier installation,
3/16"(0,48
cm) diameter
pilot holes 1/2"(1,27
cm)
deep can be drilled
into the floor.
4.
Remove template
and place bracket
on floor. Line up
holes in bracket
with marks on floor
and attach
with
4 screws provided.
Bracket must be secured to solid
floor (Figure 15). If attaching
to concrete
floor, first
drill 3/16"(0,48
cm) dia. pilot holes using masonry drill
bit.
5. Be sure the 4 leveling
legs are at the highest position
they can be.
6. Slide range into place
making sure structure
of the
range is trapped
by the anti-tip
bracket
(Figure 15).
Lower the range by adjusting
the 4 leveling
legs until
the underside
of the cooktop
is sitting level on the
countertop.
Refer to "Leveling
the Range" section.
7. After installation,
verify
that the anti-tip
bracket
is
engaged
by grasping
the top rear edge of the range
and carefully
attempt
to tilt it forward
to make sure
range is properly
anchored.
H
Floor Me
Screws
Figure 16
_LIDE
BACK
Figure
15
12

Advertisement

loading

This manual is also suitable for:

79031063100790310731007903106210079031053000