Spark Arrester - Can-Am DS 250 Operator's Manual

ENGINE
Check the level in the coolant reservoir
and refill if necessary.
Run engine at idle with the radiator cap
off. Slowly add additional coolant if
necessary.
At this point, wait until engine reaches
normal operating temperature. De-
press the throttle lever two or three
times; then add coolant if required.
Install radiator cap. Inspect all connec-
tions for leaks and check coolant level
in the reservoir.
Install access cover.

Spark Arrester

Spark Arrester cleaning
The muffler must be periodically
purged of accumulated carbon.
WARNING
Never perform this operation im-
mediately after the engine has
been run because exhaust system
is very hot. Wear eye protection
and gloves. Respect all applicable
laws and regulations.
Place transmission on FORWARD po-
sition and apply parking brake.
Remove the spark arrester from the
muffler.
______________________
86
vmo2006-014-042_a
1. Remove muffler end
2. Muffler
vmo2006-013-006_a
1. Spark arrester
Remove carbon deposits from the
spark arrester using a brush.
NOTE: Use a soft brush and be careful
to avoid damaging spark arrester.
Reinstall the spark arrester in muffler.