Can-Am DS 250 Operator's Manual page 97

1. Lens
2. Screws
Push bulb in and hold while turning
counterclockwise to release.
Install the new bulb by first pushing
in while turning clockwise. Reinstall
lens.
Beam Aiming Adjustment
To adjust beam, proceed as follows.
Loosen the bolts shown on the fol-
lowing illustrations but do not remove
them.
vmo2009-002-002_a
1. Bolts to be loosened
Adjust headlight housing angle by
hand.
Adjust both headlights evenly.
Tighten bolts when proper adjustment
is reached.
_____________________
ELECTRICAL SYSTEM
95