Muffler And Spark Arrester - Can-Am MAVERICK Sport MAX Series Operator's Manual

219001880-035_a
1. Lower radiator hose to disconnect
5. Drain cooling system completely.
6. Reinstall cooling system drain plug
and tighten to specification.
TIGHTENING TORQUE
Coolant drain
plug
7. Reinstall radiator hose and hose
clamp as noted prior to removal.
TIGHTENING TORQUE
Radiator hose
clamp
8. Fill cooling system with coolant,
COOLING SYSTEM BLEED-
refer to
ING
procedure.
Cooling System Bleeding
1. Remove the pressure cap.
2. Fill coolant system until it is filled up
to the Max line on the coolant tank.
tmo2016-010-004_a
10 N•m ± 1 N•m
(89 lbf•in ± 9 lbf•in)
3 N•m ± 0.5 N•m
(27 lbf•in ± 4 lbf•in)
______________
MAINTENANCE PROCEDURES
3. Install pressure cap.
4. Run engine at idle with the pressure
cap ON until the cooling fan cycles
on for a second time.
5. Stop the engine and let it cool down.
WARNING
In order to avoid potential burns,
do not remove the pressure cap if
the engine is hot.
6. When the engine is cool, remove
pressure cap and add coolant if re-
quired.
7. Install pressure cap.
8. After the next ride, recheck the
coolant level and refill if necessary.

Muffler and Spark Arrester

Muffler Spark Arrester Cleaning and
Inspection
CAUTION Never perform this
operation immediately after the en-
gine has been running as exhaust
system is very hot.
Remove and discard the tail pipe retain-
ing bolts and nuts.
219002008-002
1. Tail pipe retaining screws
Remove spark arrester.
109