Muffler And Spark Arrester - Can-Am DEFENDER MAX Series 2021 Operator's Manual

MAINTENANCE PROCEDURES
219002086-012
1. Grille tab
Clean air filters by washing them in
lukewarm water with mild soap. Re-
move excess water and air dry before
installation.
The installation is the reverse of the re-
moval procedure.

Muffler and Spark Arrester

Muffler Spark Arrester Cleaning and
Inspection (HD8)
CAUTION Never perform this
operation immediately after the en-
gine has been running as exhaust
system is very hot.
Remove and discard the tail pipe retain-
ing bolts and nuts.
219001920-001_a
TAIL PIPE RETAINING BOLTS AND NUTS
Remove exhaust tail pipe, gasket (dis-
card) and spark arrester.
______________
130
219001920-002_a
1. Tailpipe
2. Gasket
3. Spark arrester
Remove carbon deposits from the
spark arrester using a brush.
NOTICE
Use a metallic soft brush
and be careful to avoid damaging
spark arrester mesh.
tmo2011-001-043_a
1. Clean spark arrester
Inspect mesh of spark arrester for any
damage. Replace as required.
Inspect spark arrester chamber in muf-
fler. Remove any debris as required.
Reinstall the muffler spark arrester in
the reverse of the removal procedure.
However pay attention to the follow-
ing.
Install new gasket and fasteners.
Tighten to specification.