Servicing Engine (700); Top-Side Components; Removing Top-Side Components - Arctic Cat PROWLER HDX 2015 Service Manual

Servicing Engine (700)

Top-Side Components ................................................ 79
Removing Top-Side Components ............................... 79
Servicing Top-Side Components ................................ 82
Installing Top-Side Components ................................. 88
Left-Side Components ................................................ 92
Removing Left-Side Components............................... 93
Servicing Left-Side Components ................................ 94
Installing Left-Side Components................................. 96
Right-Side Components.............................................. 99
Removing Right-Side Components ............................ 99
Servicing Right-Side Components............................ 102
Installing Right-Side Components ............................ 103
Center Crankcase Components ............................... 106
Separating Crankcase Halves .................................. 106
Disassembling Crankcase Half ................................. 106
Servicing Center Crankcase Components ............... 108
Assembling Crankcase Half...................................... 114
Joining Crankcase Halves ........................................ 116

Top-Side Components


NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to
be addressed and to service only those components.
The technician should use discretion and sound
judgment.
AT THIS POINT

To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.

NOTE: The engine/transmission does not have to
removed from the frame for this procedure.
Removing Top-Side
Components
A. Valve Cover/Rocker Arms
B. Cylinder Head/Camshaft

NOTE: Remove the spark plug and timing inspec-
tion plug; then using a socket and ratchet, rotate the
crankshaft to top-dead-center of the compression
stroke.
1. Remove the two tappet covers.

NOTE: Keep the mounting hardware with the covers
for assembly purposes or thread them back into the
head to keep them separated.
2. Remove the twelve cap screws securing the valve
cover to the head.
3. Remove all cap screws except the two top-side cap
screws next to the spark plug. These will keep the
alignment pins in place. Note the two rubber washers
on the remaining cap screws.
4. Remove the valve cover. Account for and note the
orientation of the cylinder head plug. Note the loca-
tion of the two alignment pins.
CC001D
H1-013A
CD206
79