Rh And Lh Neutral Switch; Purpose; Location; How It Works - Toro titan zx Service Manual

ELECTRICAL
RH and LH Neutral Switch

Purpose

Used to ensure the motion control handles are in neutral
to start the unit. It is activated by moving the motion
control handles to the neutral position (handles outward).

Location

The RH and LH Neutral Switches are located in the
fender/control arm pivot area. The RH and LH switches
are serviceable by removing the control cover fastener
and the control cover (A) (Fig. 118 and Fig. 119).
A
7
A
7-6
Fig. 118
PICT-3032
Fig. 119 PICT-2010

How it Works

This single pole plunger (normally open) type switch
has two terminals. When the motion control handles are
in the neutral position (handles in the OUT position),
it pushes on the plunger, closing the contact and
connecting the terminals (Fig. 120).
Fig. 120
When the key is ON, the RH and LH Neutral Switches
get battery voltage from the Parking Brake Switch and/or
the Seat Switch.
When both of the Neutral Switches are CLOSED,
battery voltage is provided to the Kill Relay and the Fuel
Solenoid (Fig. 121).
Battery Voltage
(From Parking Brake Switch
Fig. 121

Testing

1. Disconnect the switch from the wiring harness.
2. With a multimeter set to the Ohm or Continuity
setting, check the continuity between the two switch
terminals.
3. With the plunger pushed in, there should be
continuity between the terminals. With the plunger
pulled out, there should not be continuity between
the terminals.
B
DSCN-0150a
or Seat Switch)
PICT-2007
Toro TITAN 2014 Service Manual