Parking Brake Circuit - Toro titan zx Service Manual

ELECTRICAL
Testing
1. Remove the LH control cover (A).
2. Press inward on the locking taps and push the
switch out of the mounting slot.
3. Pull the switch and harness downward, in-between
the frame and deck assembly.
4. Disconnect the harness connection to switch and
remove the switch from the unit.
5. Use a ohm meter to test the switch continuity as
shown below:
View From Back of Switch (Fig. 124)
2
3
7
Switch Plunger NOT Depressed:
Pin 2 and 3 – CLOSED, continuity between the pins
Pin 4 and 5 – OPEN, NO continuity between the pins
Switch Plunger Depressed:
Pin 2 and 3 – OPEN, NO continuity between the pins
Pin 4 and 5 – CLOSED, continuity between the pins
7-8
5
4
Fig. 124 PICT-2012

Parking Brake Circuit

(Fig. 125)
To Fuel Solenoid
To Magnito - Spark Kill
Fig. 125 PICT-2011
Toro TITAN 2014 Service Manual