Spindle Assembly - Toro titan zx Service Manual

Spindle Assembly

1. Fully seat a new UPPER bearing (pulley side) into
spindle housing until it contacts the bearing bore
shoulder. Be sure to press equally on inner and
outer race while installing bearing.
2. Turn spindle housing over.
3. Install the bearing spacer (B) into spindle housing
(C).
4. Install a new LOWER bearing (blade side) into
spindle housing until it contacts bearing spacer and
bore shoulder. Be sure to press equally on the inner
and outer race while installing bearing.
Note: While installing lower bearing, align center
bore of the bearing spacer(s) with center bore
of the bearings.
5. Install spindle shaft (D) into spindle housing.
6. Install spindle assembly to the deck as outlined in
this chapter.
Toro TITAN 2014 Service Manual
MOWER DECK
7. If necessary, install the deck onto the frame.
(Fig. 098)
Fig. 098
A. Bearing
B. Bearing spacer
A
B
C
A
PICT-2063
C. Spindle housing
6-11
6