Continuity Testing - Toro titan zx Service Manual

Continuity Testing

Terminals viewed from the back of the switch.
With the Switch "ON" (Button pulled OUT):
- Pin 2 and 5 should have continuity (closed - circled below)
- Pin 1 and 4 should have continuity (closed - circled below)
- Pin 1 and 7 should not have continuity (open)
- Pin 2 and 8 should not have continutiy (open)
(Fig. 111 and Fig. 112)
3
2
1
Fig. 111
With the Switch "OFF" (Button pushed IN):
- Pin 1 and 7 should have continuity (closed - circled below)
- Pin 2 and 8 should have continuity (closed - circled below)
- Pin 2 and 5 should not have continuity (open)
- Pin 1 and 4 should not have continuity (open)
(Fig. 113 and Fig. 114)
3
5
2
1
4
Fig. 113
Note: Switch pins 3 and 9 are not used.
Toro TITAN 2014 Service Manual
9
5
8
7
4
PICT-1005
9
8
7
PICT-1006
ELECTRICAL
Fig. 112 PICT-2004
Fig. 114 PICT-2003
7
7-3