Transaxle Replacement; Transaxle Removal - Rh Side Shown - Toro titan zx Service Manual

Transaxle Replacement

Transaxle Removal – RH Side Shown
1. Disconnect the battery terminals.
2. Safely raise and support rear of unit so rear wheels
are off the ground.
3. Remove the rear wheels.
4. Remove the parking brake return spring (A) from the
rod and spring plate.
5. Remove the retaining pin (B) from the brake linkage
then remove the brake rod from the hydro arm.
6. Remove the hydro bypass rod (C), retaining clip, and
washer then remove the rod from the unit.
7. Remove the hydro control rod nut and bolt (D)
(Fig. 071).
D
A
C
Fig. 071
Toro TITAN 2014 Service Manual
HYDROSTATIC DRIVE SYSTEM
B
PICT-3030
8. Remove the drive belt tensioner spring (Fig. 072).
Fig. 072
9. Slip the drive belt off the idler / tensioner pulleys,
then off the appropriate hydro input pulley.
10. Disconnect and plug the hydro reservoir hoses at the
hydro fitting. Be sure to capture and dispose of fluid
and shop towels properly (Fig. 073).
Fig. 073
PICT-3034
5
PICT-2047
5-9