Toro titan zx Service Manual page 65

8. Install the parking brake return spring (A).
9. Install the brake rod into the hydro arm and insert
the retaining pin (B).
10. Install the hydro bypass rod, washer and retaining
clip (C).
11. Install the hydro control rod nut and bolt (D) and
torque to specification - 17 ft-lbs. (23 Nm) (Fig. 085).
D
A
C
Fig. 085
12. Install the rear wheels and torque lug nuts to
specification – 80 ft-lbs. (108 Nm).
13. Connect battery terminals.
14. Safely lower unit.
15. Add 20w50 engine oil or Toro HYPR-OIL
hydro reservoir FULL COLD mark.
16. Perform the purging procedure as shown in this
chapter.
17. Perform the neutral and tracking adjustment
procedures as shown in this chapter.
18. Verify proper unit oil levels and function.
Toro TITAN 2014 Service Manual
HYDROSTATIC DRIVE SYSTEM
B
PICT-3030
500 to the
®
5
5-13