Pod / Fender Service; Pod / Fender Removal - Rh; Pod / Fender Installation - Rh - Toro titan zx Service Manual

CHASSIS

Pod / Fender Service

Pod / Fender Removal – RH
1. Raise seat and disconnect battery terminals.
2. Remove the (4) screws securing control panel (A) to
RH fender. Move control panel inward towards the
center of the unit.
3. Remove the (3) screws (B) securing the RH fender
to frame.
3
4. Maneuver RH fender up and off frame.
B
3-8
A
B
B
Pod / Fender Installation – RH
1. Maneuver RH fender into position.
2. Install the (3) screws (B) that secure the RH fender
to frame and torque to specification – 7 ft-lbs. (9
Nm).
3. Position control panel (A) back onto RH fender.
Install and sufficiently tighten the (4) screws that
secure the control panel to the RH fender.
4. Verify choke cable, throttle cable and wiring are
properly routed.
5. Connect battery terminals and lower seat (Fig. 011).
Fig. 011 PICT-2061
Toro TITAN 2014 Service Manual