Pto Belt Replacement - 48, 54 & 60 Inch Deck - Toro titan zx Service Manual

PTO Belt Replacement - 48, 54 & 60
Inch Deck
Squealing when the belt is rotating, blades slipping when
cutting grass, frayed belt edges, burn marks and cracks
are signs of a worn mower belt. Replace the mower belt
if any of these conditions are evident.
1. Disengage the blade control switch (PTO), move the
motion control levers to the neutral locked position
and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Lower the mower to the 3 inch (76mm) height-of-cut
position.
4. Remove the (2) belt covers from the deck.
!
WARNING
The spring is under tension when installed and can
cause personal injury.
Be careful when removing the belt.
Toro TITAN 2014 Service Manual
5. Lift the floor pan upward into service position to gain
access to the belt tensioner / idler pulley. Using a
spring tool, (Toro part no. 92-5771), remove the PTO
belt tensioner / idler spring from the deck post to
remove tension on the idler pulley (Fig. 090).
!
6. Lower the mower to the lowest height-of-cut.
7. Remove the belt from the deck and PTO pulleys.
Remove the existing belt from the unit.
MOWER DECK
Fig. 090 PICT-3035
6
6-5