Parking Brake & Linkage Installation - Toro titan zx Service Manual

Parking Brake & Linkage Installation
1. Position the brake bell crank (H) into the frame pivot
holes.
2. Install the pivot bushings (G), washers and cotter
pins to secure the bell crank into the frame.
3. Install the (3) linkage rods to the bell crank and
install retaining washers and clips.
4. Install the brake return spring (C) (Fig. 045 and 046).
C
Fig. 045
Apply Thin Coating of Engine Assembly Lube
Toro TITAN 2014 Service Manual
D
PICT-3030
E
B
A
E
5. Lubricate the brake handle pivot bolt (B) friction
surface with a light coating of engine assembly lube.
6. Install the parking brake handle into the motion
control box and torque the mounting fastener (B) to
specification – 17 ft-lbs. (23 Nm).
7. Install the parking brake linkage rod to the handle
stud using the washer and clip (A).
8. Install the LH control cover and torque the (1)
mounting fastener to specification - 5 ft-lbs. (7 Nm).
9. Install and connect the battery.
10. Verify proper parking brake function.
(Fig. 047)
1"
Apply Thin Coating of Engine Assembly Lube
E
F
H
E
Fig. 047
CHASSIS
C
Fig. 046 PICT-3037
D
G
PICT-2078
3
3-25