Figure 4-2B. Free-Run State Trace Captured By The 1630G - HP 1630A Operating And Programming Manual

Model 1630A/D/G
State Measurements
State Listing _____________________-________________________
Label> A0 R1 Time
Base >
+0000- 00000037
+0001 " 00000038
+0002 00000039
+0003 0000003E
+0004* 000
+0085* 0
+0006* 000000
®- 00000036
+0008* 00000037
+0009»- 00000038
+0010, 00000039
+0011+ 00000
+0012+ 0000
+0013* 6001
+0014+. 0004
+0015-+
04C043
0480431
0 ,48043900
0400436'00
04(-043700
04804.=800
0 ,48043900
040043600
040043700
0480,43800
048043900
040043600
040:043700
0 ,48043800
0 ,48043900
040043600
0 .0 s
2 .000 Ps
1 .480 us
1 .520
2 .000 us
2 .000 u s
1 .480 us
1 .520 ias
2 .000 u s
22 .000 us
1 .480 us
1 .520 Ps
2 .000 us
2 .000 ias
1 .520 us
1 .480 ias
Figure 4-2b. Free-run State Trace Captured by the 1630G
NOTE
The figures in this manual apply directly to the display of the 1630G, unless titled
otherwise. Therefore, when illustrating state listings the figures will appear
different than the display of a 1630A/D . The 1630A/D does not have a time tagging
function .
4 . In the State Listing, the blinking cursor is in the first column of the field next to Base . When the cursor is
in afield enclosed in brackets,[], the NEXT[] and PREY[] keys are used to select available parameter
choices for that field . Use the NEXT[] and PREY[] keys to cycle through the parameters available for
number bases . Each time one of the two keys is pressed, the data in the column changes to the new
number base and all columns are shifted to accommodate number bases requiring more characters . To
return the columns to the original position, press the blue shift key in the lower left corner of the of the
keyboard panel and the ROLL left or right key, as required .
NOTE
The blue shift key enters the alternate function/character shown in blue above
each key. When the blue key is pressed the next key pressed will enter the blue
alternate function/character . The blue key may be held down for repeated entries.
Use the blue key and the ROLL keys to move the entire display area left and right.
Use the blue shift key and LABEL arrow keys to move entire labels or, when the
cursor is within a label field, the blue shift key and an arrow key may be used to
move the cursor to the first position in the next field of the label .
NOTE
In the upper right hand corner of the display, arrows indicate the keys that may be
used to control the display. The arrows indicate the CURSOR left, right, up, or
down keys and the ROLL up or down keys .