Chapter 3. Front Panel Controls And Menu Map; Introduction; State Measurements; Timing Measurements - HP 1630A Operating And Programming Manual

Model 1630A/D/G
Front Panel Controls and Menu Map
INTRODUCTION
This chapter consists of two figures to help familiarize the user with the operation of the 1630A/D/G Logic
Analyzers. Figure 1 is the front panel keyboard of the 1630 . The function of each key is described in thefigure .
Figure 2 is a map of the available menus by selection with the INPUT or OUTPUT DISPLAYS keys at the top of
the front panel keyboard . In general, making state, timing or interactive state and timing measurements maybe
accomplished by the following steps:
State Measurements
Chapter 3
Front Panel Controls and Menu Map
" Start with the SYSTEM Specification [Configuration] menu . (power-up or press SYSTEM)
" Configure for state analysis by selecting all channels for state measurements . (use ROLL keys)
" FORMAT the input data by assigning labels to groups of probe bits . (press FORMAT)
" Specify the TRACE to be collected by the state analyzer . (press TRACE)
Timing Measurements
" Start with the SYSTEM Specification [Configuration] menu . (power-up or press SYSTEM)
" Configure for timing analysis by selecting timing channels and glitch mode (on or off) .
" FORMAT the input data by assigning labels . (press FORMAT)
" Specify the TRACE to be collected by the timing analyzer . (press TRACE)
Interactive State/Timing Measurements
" Start with the SYSTEM Specification [Configuration] menu . (power-up or press SYSTEM)
" Configure for interactive measurements by selecting a combination of state and timing channels .
" FORMAT the input data by assigning labels to both state and timing pods. (toggle FORMAT)
" Specify the TRACE to be collected by the timing and the state analyzers . (toggle TRACE)
Chapters 4 through 8 contain step-by-step procedures for setting up the specific menus.