HP 1630A Operating And Programming Manual page 20

Model 1630A/D/G
General Information
Table 1-2. Operating Characteristics (Cont'd)
HP-IL :
HP-IL connector located on rear panel for HP-IL control, or for interfacing to HP
82161A, low-cost mini-cassette drive. Not required to use analyzer, but enhances
analyzer operation as follows:
1 . Storage of user setups and measurement results; 10 different files can be
stored on one cassette .
2. When coupled with an appropriate preprocessor, allows analyzer to assume a
processor-specific personality to present data in mnemonic format .
Rear-panel BNCs :
one output BNC labeled PORT, located on rear panel, with a TTL output level ; high
=2V into 50 ohms ; low =0 .4V into 50 ohms . The BNC can be programmed from the
keyboard to provide the following signals:
1 . Pulse on State Trace Point .
2. High until State Trace Point .
3. Low until State Trace Point .
4 . High on last Sequence .
5 . High on Timing Pattern.
6 . Constant High .
7 . Constant Low.
one BNC labeled ACCESSORY POWER supplies +5V for preprocessor or logic
probes .
Weight :
1630A : 12 .6 kg (28 lb) net; 17 kg (38 lb) shipping .
1630D : 13 .2 kg (29 lb) net; 17 .7 kg (39 lb) shipping .
1630G: 13 .6 kg (30 lb) net; 18 .14 kg (40 lb) shipping .
Power requirement:
115/230 Vac, -22% to +10% ; 275W max, 48 to 66 Hz .
Service And Cali-
bration Support:
The 1630A/D/G contains all necessary interfaces to allow high-speed trouble-
shooting and calibration with automatic equipment. Guided probe techniques,
utilizing signature analysis under computer control, coupled with special test
instruments and fixtures allow most failures to be isolated to the component level in
a minimum amount of time . After repair, full and complete calibration can be
accomplished in minutes, using the same equipment. Since this integrated design
can only be serviced efficiently and economically with this automated system, all
major HP service facilities have installed this special equipment . This HP investment
will provide you with the fastest, most complete and lowest cost repairs and
calibrations . For those companies where economies of scale make in-house repair
and calibration cost-effective, an option is available that provides the special
hardware, software and related documentation and training to allow 1630A/D/G
repair . Additional test equipment is required . Contact your local HP sales
representative for further information.
1-9/(1-10 blank)