Table of Contents
Advertisement
Model 1630A/D/G
Installation
INTRODUCTION
The purpose of this chapter is to describe how the analyzer is set up and the probe cables are connected for
measurements in a system under test . The self test of the analyzer and messages that may be displayed during
the self-test are also described .
INITIAL INSPECTION
To avoid hazardous electrical shock, do not perform electrical tests when there are signs
of shipping damage to any portion of the outer enclosures of the instrument (covers and
panels) .
Inspect the shipping container for damage . If the shipping container or cushioning material is damaged, it
should be kept until the contents of the shipment have been inspected mechanically and electrically . If the
contents are incomplete, if there is mechanical damage or defect, or if the instrument does not pass the self
test, notify your nearest Hewlett-Packard Sales and Service Office . If the shipping container is damaged, or the
cushioning materials show signs of stress, notify the carrier as well as the Hewlett-Packard office . Keep the
shipping materials for inspection by the carrier.
POWER REQUIREMENTS
WARNING
The 1630A/D/G Logic Analyzer requires a power source of either 115 or 230 Vac -22% to +10% ; single
phase,
48 to 66 Hz ; 275 watts maximum power.
WARNING
Chapter 2
Installation
This is a Safety Class I product (provided with a protective earth terminal) . An
uninterruptible safety earth ground must be provided from the main power source to the
product input wiring terminals, power cord, or supplied power cord set. Whenever it is
likely that the protection has been impaired, the instrument must be made inoperative
and be secured against any unintended operation .
If this instrument is to be energized via an autotransformer for voltage reduction, make
sure the common terminal is connected to the earthed pole of the power source .
Hide quick links:
Advertisement
Table of Contents
