HP 1630A Operating And Programming Manual page 159

Model 1630A/D/G Using The Tape Memory Accessory
3. Move the highlighted bar to the "COPYFILE" line.
4 . Press the INSERT key . This causes the analyzer to read the COPYFILE program . When finished, the
analyzer will place the following messages on screen : "COPYFILE : Press INSERT to copy highlighted
file" at the bottom of the menu, and "Press STOP to exit COPYFILE" at the top of the menu .
5. Move the highlighted bar to the write-protected inverse-assembler file you want to copy .
6. Press the INSERT key . This reads the inverse-assembler file into the analyzer along with the copyfile
program . When finished, the message at the bottom of the menu will change to "COPYFILE : Press
DELETE to store copy in highlighted file" .
7. Now open the digital cassette drive, remove the tape cassette, and install the new cassette that you want
to contain your user file. The analyzer will display the directory of the new tape .
8. Move the highlighted bar to the location where you want to store the inverse-assembler routine .
9. Press the DELETE key . The analyzer will write the inverse-assembler routine to the tape at the location
you selected . All attributes of the source file will be transferred . Because the source file was write-
protected, your user file will also be write-protected.
10. You can now repeat steps 7 through 9 to create as many cassettes with inverse-assembler routines as
desired .
11 . Press the STOP key . This exits the COPYFILE program and returns the analyzer to normal program
execution.
E- 5/(E-6 blank)