How To Create A New Disc File; How To Find A Disc File; How T O Find A Disc File - HP 1630A Operating And Programming Manual

Model 1630A/D/G
Using The Disc Memory Accessory
4. Load the desired file from the disc into the logic analyzer memory by placing the file name to be loaded
next to the directory pointer (greater than sign ; >) by pressing the ROLL keys . Then move the cursor to
the Operation field at the bottom of the menu and press NEXT[], PREV[ ] keys until [Load] is displayed,
then press the INSERT key to actually load the file from the disc .
HOW TO CREATE A NEW DISC FILE
1 . Place the cursor in the Operation field and press NEXT[], PREV[] keys until [Store] is displayed.
2. Press the CURSOR right key to place the cursor in the Type field and press NEXT[], PREV[ ]keys until
the type of data you wish to store is displayed as follows:
a. [config] - stores all menu configurations, except Storage Operations on disc . The clock data on the
peripherals menu is not stored .
b. [state] - stores all state data .
c . [timing] - stores all timing data .
d. [all] - stores all configuration, state and timing information.
3. Press the CURSOR right key once to place the cursor in the Name field. Enter a Name in the name field .
NOTE
The File Name must begin with an alphabetic character, be a maximum of 9
characters and contain only alpha and numeric characters .
4. Add a description of the file as required, then press the INSERT keyto actually store the data . To place a
space in the description use the DON'T CARE key. CLEAR will clear the entire description field .
While the data is being stored, the disc drive indicator lamps will be lit. After the disc operation the new file
name will appear in the directory of the menu, aligned with the indicator ( ) .
HOW TO FIND A DISC FILE
1 . Enter the [Storage Operations] menu and load the file directory from the disc .
2. Place the cursor in the Operation field and select [Find] .
3. Press the CURSOR right key once and select the proper type of file . The type file [prog] is a file that has
been downloaded from another system, and the "prog" type label is displayed . The "unknown" Type file
is written by another controller, therefore, the 1630 cannot identify the file type .
4. Move the cursor to the Name field and enter the name of the file that is to be found .
NOTE
If the file type or file name is not correct the file will not be found and the error
message "ERROR file not found" will be displayed .
5 . Press the INSERT key to actually find the file name in the directory.
NOTE
The file name is located in the directory, however, the file must be loaded to the
1630 memory in a separate operation. If the file is not found, the directory
pointer will be left pointing to the file that is alphabetically following thefilethat
could not be found.
D- 3