set product
OK
To set again the data in sale mode keep pressed for at least 8 seconds the key on the display board
inside the machine, until the display shows the message:
set product
OK
12.5.12
Pre-setting of the snacks' sale prices
One price for each snack slot (11, 12 etc.) available can be memorised. When a selection is matched to
a price set to zero, the selection is in the free vend mode.
To modify sale prices, in the programming mode, press button 1 until the sub-menu:
PROGRAMMING - - - -
- PRICES SNACK - - - -
is visualised.
Press buttons 2 and 3 and select the price to be modified. For example:
PRICE X
will appear on the display. Press button 4 and 5 to modify the value of the price displayed.
Press button 1 to confirm the set data.
When the invitation message is visualised and with machine open and switched on, the pre-set sale
prices can be by-passed as described in the paragraph 12.5.3.
12.5.13
Reading of the snacks' sales data
This sub-menu concerns the reading of the snacks' sales data. The machine keeps various counters
stored, which allow a direct reading for consumption and cashing.
Read the sales data, in the programming mode, by pressing button 1 until the sub-menu
SALES DATA - - - - - -
SNACK - - - - - - - - - -
is displayed.
Then press button 2 and the following counters are shown in sequence:
T CYCLES
This value indicates the total sale cycles of the machine. This is the same value, which is shown when I
pressed the key inside the machine on the display board and then button 2. This value cannot be set to
zero.
XXXX
XXXXXX
45
MAN1100105 V. 9 – 09/11/2011