Rheavendors Group XS Instant Installation And Maintenance Manual page 25

- pre-setting for the use of the system of parallel payment;
- the clock function disabled;
The programming of the machine must be modified only if the pre-set factory parameters are not
complying with the required use.
12.3 How to enter and exit from the programming mode
To modify the operation parameters of the machine it is necessary to enter in the programming mode.
To enter press the internal key on the display board inside the machine. The display shows:
1=PROG
3=FREE
2=DATA 4=CLEAN
5=MAINT.
Press button 1. The display shows:
PROGRAMMING
BUTTON 1 - - - - - - - -
Once the parameters have been modified, press again the key on the display board inside the machine
to exit from the programming. The display shows:
END PROGRAMMING
- - - - - - - - - - - - - - - - -
12.4 Buttons used in the programming mode
Programming is carried out by pressing the buttons on the selection keypad. Notably:
•
with button 1 the sequence of programming sub-menus is visualised;
•
with button 6 the sequence of programming sub-menus is visualised in the reverse direction;
•
with button 2 the sequence of specific programming functions for the chosen sub-menu is
visualised;
•
with button 3 the sequence of specific programming functions for the chosen sub-menu is
visualised in the reverse direction;
•
with button 4 the value of the visualised function is increased or selected;
•
with button 5 the value of the visualised function is decreased or selected.
12.5 Programming sub-menus
Access to the programming sub-menus is possible at any time, after entering the programming mode
and pressing the button 1 on the selection keypad. These sub-menus are repeated cyclically after the
last one has been displayed.
The sub-menus and their display order are as follows:
25 MAN1100105 V. 9 – 09/11/2011
FREE