Rheavendors Group XS Instant Installation And Maintenance Manual page 38

Pressing buttons 4 and 5 it is possible to select one of the 3 available languages.
Pressing again button 2, the display shows:
enable snack
0=NO
With this parameter is possible to enable the connection with the SNACK DAMIAN. Programme this
value at 1 to enable the connection.
Pressing again button 2 the display shows:
First Installation
0 = First
Pressing button 4 and 5 set this parameter at 0 to activate the First Installation procedure at the
switching on of the machine as described at the paragraph "Start up operations".
At the end of the programming, press button 1 to confirm the set data.
12.5.6 Diagnostics programmes
In the programming mode, a certain number of diagnostics programs can be carried out in order to test
the correct operation of some components of the machine.
To modify the parameters, in the programming mode, press button 1 until the sub-menu
DIAGNOSTICS - - - - -
- - - - - - - - - - - - - - - - -
is visualised.
Press button 2 and
HABIL. DISPLAY
TEMPERAT. 1=YES 0
is displayed.
According to the value of the parameter, which can be modified with buttons 4 and 5, the inside
temperature of the machine is displayed in real time. Set the parameter to 1 (it is normally 0) to have the
display of temperature. To read the temperature, press button 1 and exit from the programming mode.
Pressing again button 2 the display shows:
VOLTAGE
Volt:
This parameter visualises the value of the supply tension at the 24 V actuators. This value should be
included between 24 V and 28 V.
Pressing button 2 again the display shows:
MAN1100105 V. 9 – 09/11/2011
1=YES X
1
XX.X
38