Rheavendors Group XS Instant Installation And Maintenance Manual page 42

is displayed. Press buttons 4 and 5 and modify the value of the token.
By pressing button 2 the following message from
coin rest A 0=ACC
to:
coin rest P 0=ACC
is displayed. Press buttons 4 and 5 and modify the values of the function displayed. Set at 0 each coin
from A to P, which the coin-mechanism must accept, and at 1 all the coins, which the machine must not
accept. This set of parameters is working only when the tubes of the coin-mechanism have inside
enough coins to give back change.
Pressing again button 2 the display will show the set of the parameters that will be active when the
tubes of the coin-mechanism don't have enough coins inside to give back change. From:
COIN A NO-REST
until:
COIN P NO-RE ST
Press buttons 4 and 5 and modify the values of the function displayed. Set at 0 each coin from A to P,
which the coin-mechanism must accept, and at 1 all the coins, which the machine must not accept.
By pressing button 2 the following messages:
TUBES MDB
is displayed. This value means the total of money inside the tubes of the coin-mechanism.
At the end of programming, press button 1.
12.5.9 Pre-setting of functions based on the internal clock
The machine is equipped with an internal clock able to up-date the time also when the machine is
switched off. Some functions of the machine are based on the internal clock:
to modify the pre-settings of the clock, in the programming mode, push the button 1 until the sub-menu
PROGRAMMING - - - -
CLOCK - - - - - - - - - - -
is displayed.
MAN1100105 V. 9 – 09/11/2011
X
X
X
X
XXXXXXXX
42