Operating & Maintaining the Objet24 3D Printer
Calibrating the
Load Cells
6–54
Load cells are sensors that measure the weight of the material cartridges
and the waste container in the printer. It is important that you periodically
check that the weight measurements are accurate, both for convenience and
to prevent unnecessary waste of printing materials. It is recommended that
you calibrate the load cells after 500 hours of printing, or every six months.
To calibrate load cells:
1. Start the Load Cell Calibration wizard from the Options menu (see
figure 6‐28 on page 23).
2. Select one or more load cells that you want to calibrate, and click
Figure 6-78: Load cell selection
3. Remove the cartridge or container, as instructed by the wizard, and
close the materials drawer.
Important: Make sure that the materials drawer is closed
before continuing. Otherwise, calibration will be affected.
4. Select the confirmation check box and click
Figure 6-79: Confirmation of cartridge removal
Next
.
Next
DOC-34014 Rev. C
.