Cleaning The Exterior Panels; Backing-Up And Restoring Printer Settings; Reinitiate Wizard - Stratasys Objet24 User Manual

Cleaning the
Exterior Panels
Backing-Up
and Restoring
Printer
Settings
ReInitiate
Wizard
DOC-34014 Rev. C
8. Place the fireproof cover over the waste container, making sure that the
drain tube is free and not bent.
Figure 6-101: Fireproof cover installed over the waste container
Note: Operating the printer without the waste-container cover results in an
inaccurate measurement of the waste weight, which will cause waste to
overflow into the printer.
9. Close the materials drawer.
Dispose of the full waste container in accordance with environmental and
safety requirements.
The painted exterior plastic panels of Objet 3D printers have a durable
finish, offering excellent chemical resistance to common cleaning materials.
However, it is recommended that you use only a mild soap solution for
routine cleaning.
Printer modes and configuration settings are stored in files on the printer
computer. You can back up these files, and restore them, if necessary, using
desktop icons.
Figure 6-102: Backup and restore desktop icons
One of the wizards listed in the Options menu is ReInitiate. You normally do
not have to run this wizard. The process that this wizard controls runs
automatically, when needed, as part of the Pre‐print mode (before printing
begins). Run this wizard only if a Stratasys Customer Support engineer
instructs you to do so.
Objet24 User Guide
6–65