Built-In Tests - Stratasys Objet24 User Manual

Operating & Maintaining the Objet24 3D Printer

Built-in Tests

Accessing

Built-in Tests

Test Interface The Built In Tests screen lists pre‐configured tests.
Test Results To save and view a report of all of the tests:
6–62
A sanity check of the software parameters is available from the Built‐in
Tests interface. Because this effects the operation of the printer, you can
only open the Built‐in Tests interface when the system is not printing.
To open the Built-in Tests screen, do one of the following:
•
From the Options menu, select
•
Press .
Ctrl+Alt+B
Figure 6-95: Selecting Built-In Tests from the Options menu
Figure 6-96: Built In Tests screen
Status
The "S" column shows the results of the test after you run it:
Test successfully completed.
Test failed.
Unknown results. (The test has not been run yet.)
To run the test:
Select the check box and click
After you run the test, the Save and View command buttons are added to
the Built In Tests screen.
Figure 6-97: BIT command buttons
Use the Save and View command buttons.
.
Built-In Tests
.
DOC-34014 Rev. C