Ip Address Write - Omron SYSMAC CJ1W-EIP21 Operation Manual

FINS Commands Addressed to EtherNet/IP Units or Built-in EtherNet/IP Ports
• An error response will be returned if the IP address conversion method in the system mode settings is set
for automatic generation on the FINS/UDP Tab Page of the Unit.
Response Codes
Response code
0000 Normal end (echo reply received from the remote node)
1001 Command too large
1002 Command too small
1003 The number of records specified does not match the sent data
length.
110C The number of records is not between 0 and 32.
The FINS node address is not between 1 and 126
The IP address is 0.
2307 IP address conversion method is set for automatic generation.

IP ADDRESS WRITE

Write the local IP address and the subnet mask in the CPU Bus Unit System Setup.
Command Block
27 57
Command IP address
code
Response Block
27 57
Command Response
code code
Parameters
IP Address (Command)
Specify the local IP address of the EtherNet/IP Unit or built-in EtherNet/IP port using 4 pairs of 2-digit hexadec-
imal numbers in the range 00.00.00.00 to FF.FF.FF.FF (0.0.0.0 to 255.255.255.255 decimal). Specify 0.0.0.0 to
enable the local IP address set in the allocated DM Area words.
Example: 150.31.2.83
96 1F 02 53
Subnet Mask (Command)
Specify the local IP address of the EtherNet/IP Unit or built-in EtherNet/IP port using 4 pairs of hexadecimal
numbers in the range 00.00.00.00 to FF.FF.FF.FF (0.0.0.0. to 255.255.255.255 decimal).
Example: 255.255.255.255
FF FF FF 00
404
Description
Subnet mask
Appendix E