Omron SYSMAC CJ1W-EIP21 Operation Manual page 388

Connection Status Codes and Error Processing
Connection status
General Additional
Status Status
(hex) (hex)
01 0316 Error code returned from target:
There was a parameter error in
the frame used to close the con-
nection.
01 031C Error code generated in origina-
tor:
Some other error occurred.
08 --- Error code returned from target:
There is no Forward Open or
Large Forward Open service in
the target device.
D0 0001 Error code generated in origina-
tor:
The connection operation is
stopped.
D0 0002 Error code generated in origina-
tor:
The connection is being opened
(opening processing in
progress).
362
Source of error
Configuration 1
This error does
not occur.
This error does
not occur.
This error does
not occur.
The connection
was stopped
because the Tag
Data Link Stop Bit
was turned ON, or
the settings data
is being down-
loaded.
Either turn ON the
Tag Data Link
Start Bit, or wait
until the settings
data has been
downloaded.
Includes Control-
ler stop errors,
Unit failure, and
EM bank files at
the refresh desti-
nation. To handle
these errors, refer
to 14-2-1Errors
Occurring at the
EtherNet/IP Unit
or built-in Ether-
Net/IP port.
Wait until the
opening process-
ing is completed.
Handling
Configuration 2 Configuration 3
Depends on the tar- Depends on the orig-
get's specifications. inator's specifica-
(Contact the target tions. (Contact the
device's manufac- originator device's
turer.) manufacturer.)
The originator gener- Depends on the orig-
ates this code when inator's specifica-
an unsupported tions. (Contact the
response code is originator device's
returned from the manufacturer.)
target in reply to a
connection-opening
request.
Depends on the tar- Depends on the orig-
get's specifications. inator's specifica-
(Contact the target tions. (Contact the
device's manufac- originator device's
turer.) manufacturer.)
The meaning of this Depends on the orig-
error code is defined inator's specifica-
by each vendor, so it tions. (Contact the
depends on the tar- originator device's
get's specifications. manufacturer.)
(Contact the target
device's manufac-
turer.)
The meaning of this Depends on the orig-
error code is defined inator's specifica-
by each vendor, so it tions. (Contact the
depends on the tar- originator device's
get's specifications. manufacturer.)
(Contact the target
device's manufac-
turer.)
Section 14-3