Omron SYSMAC CJ1W-EIP21 Operation Manual page 20

Using Unit Version Label
Unit Versions and CX-Programmer Versions
Unit Version Notation
Product nameplate
Ver. 1.0 or later number
shown to right of the lot
number
CIP Revisions and
Unit Versions
xx
Note The unit version will be displayed in the Unit Manufacturing Information Dialog
Box.
The following unit version label is provided with the EtherNet/IP Unit.
This label can be attached to the front of the EtherNet/IP Unit to differentiate
between EtherNet/IP Units with different unit versions.
Use the following versions of the CX-Programmer to make the Unit settings for
the EtherNet/IP Unit.
Unit version
Unit version 1.0
Unit version 2.0
* The following auto update must be applied to use CX-Programmer version 8.0:
CX-Common Components/CPS Upgrade Software 2008.08 0302
In this manual, the unit version of a EtherNet/IP Unit is given as shown in the
following table.
Notation used in this manual
Ethernet Unit Ver. 1.0 or later (See note.)
Note Some Support Software products call the EtherNet/IP Unit version the "revi-
sion." "Revision" is also sometimes used in this manual.
The CIP revisions corresponding to the unit versions of the EtherNet/IP Unit
are given in the following table.
Unit version
Version 1.0
Version 2.0
CX-Programmer
Ver. 7.1 or lower
--- OK*
--- OK
Information without reference to specific Unit
Versions applies to all versions of the Unit.
CIP revision
Revision 1.01
Revision 2.01 or 2.02
Unit version
Ver. 8.0 Ver. 8.02 or higher
OK
OK
Special remarks