Omron SYSMAC CJ1W-EIP21 Operation Manual page 245

Using FINS Applications
CX-Programmer/CX-Integrator
Node number: 1
IP address: 192.168.250.1
FinsGateWay Version 2003
Ethernet port
Ethernet or EtherNet/IP (Network number: none)
FINS/TCP method
■
System Configuration Example 3: Connecting the CX-Programmer Online
Using the FINS/TCP Method
In this example, an online connection is made by FINS/TCP to a PLC on an
Ethernet network (PLC1 in the diagram below) from a CX-Programmer/CX-
Integrator connected to the Ethernet network.
Conditions
• FINS/TCP method
EtherNet/IP Unit
CX-Programmer's Change PLC Dialog Box
Settings for target PLC (PLC1)'s Change PLC Dialog Box
PLC name
Network classification
Network Tab FINS destination
Page
Frame length
Response monitor time
CX-Programmer's FINS/TCP Tab Page in Edit Parameters Dialog Box
Item
FINS/TCP Port
IP Router Table
Not set. (All defaults are used.)
FinsGateway ETN_UNIT Setup
TCP Nodes Tab Page: Ethernet Node Definition Dialog Box
Item
Node address
IP address
Destination port number
Keep-alive setting
IP address conversion: Automatic generation method (dynamic)
EtherNet/IP Unit node number: 2
EtherNet/IP Unit IP address: 192.168.250.2
Target: PLC1
Network number
Node address
Setting
Default (9600)
None
Setting
2
192.168.250.2
9600
Selected (yes)
Section 8-5
Setting
PLC1
FinsGateway
0
2
2,000 bytes
2 seconds
219