Table of Contents
Advertisement
•
When making a call using the LDAP database, you can specify whether or not to apply an outgoing
access code for each attribute that was acquired as a search result. (System setting) The only
Automatically applied access codes applied are [Local outgoing access codes], other access codes are
not supported.
The operation becomes a transmission operation attached with a Caller ID when applying an outgoing
access code. Also in this case, the acquired telephone number is displayed with the outgoing access
code shown in front of the telephone number. (Initial value: attributes 1–3 for telephone numbers are not
applied)
However, if you use this phone book from an outside line capture state, the access number will not
automatically be applied. (Note: In this case, the Caller ID will be displayed but this number will not be
dialed.)
[Incoming Call Name Retrieval Display]
•
During an incoming call, the caller number is first searched for in Station System Dial, then in System
Speed Dial, and finally in the LDAP database. Finally, the name of the data consistent with the number of
the caller is displayed.
•
In order to perform Name Retrieval Display during a call, the LDAP Name Retrieval and Display
availability System Setting for during a call must be Enabled.
•
The LDAP database is queried. If there is no matching data, a name from the network will be displayed; if
there is no name registered to the network, no name will be displayed.
•
If any of the following cases are detected when using the LDAP database, a name from the network will
be displayed. If there is no name registered to the network, no name will be displayed.
1.
When you cannot connect to the LDAP database
2.
When you cannot login to the LDAP database
3.
During a data search time-out
•
During a call, when the response to the incoming call, and the search results during a call after the
response have been reported before the LDAP database search results are reported to the NSX, the
reported LDAP data will be displayed after being overwritten.
•
When a name which matches the LDAP database is displayed, the displayed name is saved in Call
History up to 20 characters and that name will be displayed as an indication of the Call History.
PC Programming Manual References
10.3 PBX Configuration—[2-3] System—Timers & Counters—Dial / IRNA / Recall / Tone
Operating Manual References
1.2.3 Redial
2.6.6 Quick Dialling
Description
An extension user can access an extension or feature by simply dialling a 1–8 digit Quick Dialling number.
Conditions
•
Quick Dialling is convenient in cases such as the following:
–
Room service calls in a hotel
–
Calling another branch via the public network.
•
Quick Dialling numbers follow the flexible numbering plan.
2.6.6 Quick Dialling
Feature Manual
103
Advertisement
Table of Contents
