Choosing And Using The Brushes; Suggested Power Cable Extension - COMAC Vispa 35E Use And Maintenance Manual

POLYPROPYLENE BRUSH (PPL)
Used on all types of floors. Good resistance to wear and tear, and hot water (no greater than 60°C). The Polypropylene brush is non-hygroscopic and
therefore retains its characteristics even when working in wet conditions.
PAD HOLDER
The pad holder is recommended for cleaning shiny surfaces.
There are two types of pad holders of the CENTRE LOCK type, equipped with a snap-type central locking system in plastic that allows the abrasive floor
pads to be perfectly centred and held without any risk of them becoming detached:
1. fitted with a series of anchor points that allow the abrasive floor pad to be held and dragged while working
2. fitted with a series of groups of bristles that allow the abrasive floor pad to be held and dragged while working
TABLE FOR CHOOSING THE BRUSHES
Machine No. of
brushes
VISPA 35E 1
CAST SCHUKO PLUG

CHOOSING AND USING THE BRUSHES

Code Type of bristles
421701 PPL
422213 Pad holder – anchor
422001 Pad holder – bristles

SUGGESTED POWER CABLE EXTENSION

∅ Bristles ∅ Brush
0.6 355
355
0.9 355
19
Notes
CAST SCHUKO PLUG