Figure 42 Change Network Settings Screen - Quantum px720 User Manual

Figure 42 Change Network
Settings Screen
Quantum PX720 User's Guide
Back
a To set the IP address, subnet mask, and gateway, use the up and
down arrows to select the appropriate number and press
to accept.
b To enable/disable DHCP, use the up and down arrows to toggle
between enable/disable. Press
library is not connected to a network which uses a DHCP server
to assign IP information, disable this function.
For the network information such as the IP address to be
Note:
active, the library must reboot.
4 To edit the setup information, use the up and down arrows to
highlight the section and press
• To change the password, use the up and down arrows to select
Change Password and press
enter a 6-digit password using the numbers provided on the
OCP. Press
Select
re-enter the password to confirm.
• To restore the factory defaults, use the up and down arrows to
select Restore Factory Defaults and press
Chapter 2 Basic Library Operations
Select
to accept the setting. If your
Select
.
Select
. To change the password,
Select
to accept the new password. When prompted,
OCP Components
Select
.
Select
70