Figure - Quantum px720 User Manual
Hide thumbs
Also See for px720:
- Warranty (6 pages) ,
- Quick start manual (7 pages) ,
- Unpacking and installation instructions (38 pages)
Table of Contents
Advertisement
Quantum PX720 User's Guide
•
To set the barcode length, use the up and down arrows to select
the barcode length and press
•
To enable autoclean, use the up and down arrows to select
Autoclean and press
•
To enable auto unload, use the up and down arrows to select
Auto unload and press
•
To configure the number of tape drives in the cabinet, use the up
and down arrows to select the number of drives and press
•
To configure the number of slots in the cabinet, use the up and
down arrows to select the number of slots and press
•
To enable the both the left and right load ports, use the up and
down arrows to select Both Load Ports and press
library is automatically reconfigured.
•
To enable P7000 identity, use the up and down arrows to select
Identify as ATL P7000 and press
computer to identify the cabinet as a P7000 library.
•
To enable the left load port, use the up and down arrows to select
Left Load Port and press
reconfigured.
•
To enable the right load port, use the up and down arrows to
select Right Load Port and press
automatically reconfigured.
5 When you are finished viewing/editing the setup information, press
to return to the
Back
Note:
For the network information, tape drive configuration, and
number of slots to be active, the library must reboot.
Service Information/Options
The Service Information screen is used by Customer Service only.
Event Log Information
To view the event log:
Chapter 2 Basic Library Operations
.
Select
.
Select
.
Select
Select
. The library is automatically
Select
Select
screen.
Menu
OCP Components
Select
.
Select
. The
Select
. This allows the host
.The library is
.
2
2
71
Advertisement
Table of Contents
