Quantum px720 User Manual page 62

Quantum PX720 User's Guide
6 To edit the setup information, use the up and down arrows to
highlight the section and press
• To set the IP address, subnet mask, and gateway, use the up and
down arrows to select the appropriate number and press
to accept.
• To enable/disable DHCP, use the up and down arrows to toggle
between enable/disable. Press
library is not connected to a network which uses a DHCP server
to assign IP addresses, disable this function.
• To change the password, use the up and down arrows to select
Change Password and press
enter a 6-digit password using the numbers provided on the
OCP. Press
Select
re-enter the password to confirm.
• To enable drive autoclean, use the up and down arrows to select
Drive Autoclean and press
• To enable drive autounload, use the up and down arrows to
select Drive Autounload and press
• To enable the left load port, use the up and down arrows to select
Left Load Port (16) and press
• To enable the right load port, use the up and down arrows to
select Right Load Port (32) and press
7 When you are finished viewing/editing the setup information, press
twice to return to the
Back
8 From the screen, press
Home
9 Before the network information can become active, the cabinet must
reboot. To reboot the cabinet, use the up and down arrows to
highlight the cabinet and press
10 Use the up and down arrows to select the reboot option and press
.
Select
The library reboots.
The library is now ready for operation. For more information on
Quantum PX720 remote management, see
Chapter 1 Library Description
.
Select
to accept the setting. If your
Select
. To change the password,
Select
to accept the new password. When prompted,
.
Select
Select
.
Select
Select
screen.
Home
to enter the operations screen.
Ops
.
Select
chapter 3
Getting Started
Select
.
.
on page 86.
39