Quantum Px720 User's Guide - Quantum px720 User Manual

Quantum PX720 User's Guide

Field Description
Unload drives When enabled, the library will automatically send
an unload command to the drive prior to the
automatically
application moving the cartridge back to a bin.
Note: This option should be enabled if the
application does not issue the unload command to
the drive prior to sending the move command.
Return drive When enabled, the tape drive automatically
returns the serial number for each tape drive to
serial numbers
to host the host.
When enabled, an identifier of ATL P7000 will be
Identify as ATL
included in the inquiry message sent to the host.
P7000
Changing the library identification requires
activation.
Prefix media Enables/disables swapping media type prefix
type in barcode from the back of barcode to the beginning.
Configures the number of maximum characters of
Barcode length
tape cartridge barcode label to return to the host;
valid values are 1 through 9; 0 indicates to return
all characters in the barcode.
Configured Only available in a NON-partitioned library.
Enter the number of configured drives and click
Drives
Apply
with the new drive count. The default number of
configured drives is the number of potential drive
bays within the cabinet. This number may exceed
the actual number of installed tape drives.
Only available in a NON-partitioned library.
Configured
Slots Enter the number of configured slots and click
Apply
with the new slot count. This will be the number
of slots available and reported to the host.
3 Click to return the library to its original settings.
Reset
Chapter 3 Quantum PX720 Remote Management
. Click to reconfigure the library
Activate
. Click to reconfigure the library
Activate
Setup
147