Printer Protocol; Buffer Size - Printronix P9212 Setup Manual

Printer Protocol

The Printer Protocol parameter enables you to set the desired printer
emulation.
•
P-Series:
•
Serial Matrix:
•
P-Series XQ:

Buffer Size

The Buffer Size parameter allows you to select the number of characters that
the printer internal input buffer can contain, including non-printable
characters. You can change the buffer size, depending on your host
computer's requirements.
•
2048 characters
•
512 characters
•
1024 characters
3–34
Standard Printronix P-Series emulation. The
command delimiter is an ASCII code that is
configured from the control panel via the Select
SFCC parameter. (The ASCII Code SOH (01 hex) is
the default command delimiter. See the description
of the Select SFCC parameter on page 3–38.)
IBM Graphics Printer emulation; uses ASCII Code
ESC (1B hex) as a command delimiter.
Printronix P300 or P600 printer emulation; uses no
command delimiters.
Configuring the Printer