Setting Analyze Job Mode - Printronix P9212 Setup Manual

Setting Analyze Job Mode

Step
1.
ON LINE
2.
Raise the printer cover.
3.
4.
5.
6.
7.
ENTER
8.
Verify that a new ribbon has been installed. Refer to the section "Setting Up a New Ribbon" on
page 6–6 if necessary.
9.
CLEAR
10.
Close the printer cover.
RibbonMinder
Press Result
Off–Line
Ready
ENTER Switch
+
Not Locked
Ribbon Life
Ribbon Life
New Ribbon
Ribbon Life
UNTIL
Analyze Job
Ribbon Life
Change Ribbon
Off–Line
Ready
Notes
The printer must be off-line to
xxx%
1
change the configuration.
Press both keys at the same time.
Unlocking permits configuration
changes.
xxx%
xxx%
xxx%
Pressing ENTER sets the
1000
"Analyze Job" mode. A message
to change the ribbon appears.
xxx%
1
6–15