Dataproducts Parallel Interface - Printronix P9212 Setup Manual

Dataproducts Parallel Interface

The Dataproducts parallel interface allows the printer to operate with a
50-pin AMP Ampilite HDH-20 data cable connector. The length of the data
cable from the host computer to the printer must not exceed 40 feet
(12 meters). An adapter cable to accept the 50-pin Winchester MRAC50P
connector is also available from your authorized service representative.
Input Signals
Signal
DATA LINE 1
Return
DATA LINE 2
Return
DATA LINE 3
Return
DATA LINE 4
Return
DATA LINE 5
Return
DATA LINE 6
Return
DATA LINE 7
Return
DATA LINE 8
Return
DATA STROBE
Return
PAPER INSTRUCTION 30
Return
Note: Pins not listed are not connected.
Printer Interfaces
Table 4–1. Connector Pin Assignments for
Dataproducts Interface with AMP Connector
Output Signals
Pin Signal
19 READY
3 Return
20 ONLINE
4 Return
1 Data Request
5 Return
41
6
34
7
43
14
36
18
28
35
38
2
44
Miscellaneous
Pin Signal
22 CABLE VERIFY
40
21 GROUND
42
23
37
Pin
45, 46
39
4–3