Printronix P9212 Setup Manual page 57

Step
1.
Make a configuration printout. Refer to "Printing the Current Configuration" on page 3–12. You
may skip this step.
2.
Determine which parameters you want to change, and what their new values should be. (In this
example, we are changing the value of the Line Spacing parameter from "Set at 6 LPI" to "Set at 8
LPI".)
3.
Press:
4.
Raise the printer cover.
If you intend to save your changes, they will be saved into the current
configuration. To ensure you have the correct Configuration selected and
loaded, do the following step.
5.
6.
7.
8.
9.
10.
Configuring the Printer
Press
ON LINE
IMPORTANT
CONFIG
UNTIL
+
UNTIL
Result
Off–Line
Ready 1
Load Saved
Completed X
ENTER Switch
Not Locked
Ribbon Life
Paper Format
Line Spacing
Line Spacing
Set at 6 LPI *
Notes
The printer must be
off-line to change the
configuration.
Selects and loads X
(Configuration 1, 2, 3, or
4).
Unlocking the ENTER key
allows you to make
configuration changes.
Asterisk (*) indicates this
is the current setting.
(6 LPI is also the factory
default.)
3–15