Printronix P9212 Setup Manual page 37

3. Lower the forms thickness lever. Set it to match the paper thickness. If
you are using single-part forms, set the forms thickness lever so that "A"
is next to the indicator. (See Figure 2–16.)
NOTE: Do not set the forms thickness lever too tightly; excessive friction
A
B
C
4. Press CLEAR to clear the "Platen Open" fault.
5. Press SET TOF. The paper moves downward to the top-of-form print
position.
6. Continue with the next section to install the ribbon.
Setting Up the Printer
can cause paper jams, smeared ink, or wavy print.
Thin
Medium
Thick
Figure 2–16. The Forms Thickness Scale
2–19